410-643-9970
Support Hours
Monday - Friday | 9AM - 4PM EST
  • Support
  • PRS Locking Tuners (Phase II, III, S2)

PRS Locking Tuners (Phase II, III, S2)

  1. Line up the hole in the tuning peg so that it is pointing at the nut slot.
  2. Put the string through the hole and keep as little slack as possible.
  3. Turn the cap screw so that it is finger tight.
  4. You may use a coin to further tighten the cap screw if needed, but no more than 1/8th turn. Do not over tighten.
  5. Bend the string backwards towards the outside of the headstock to help lock in place.
  6. Bring the string to pitch and cut off the excess string.

PRS Phase II Locking Tuners